Automatic Wire Feeder Wire Feeder Failure

Automatic Wire Feeder Wire feeder failure

1. It is recommended because the welding cable is too small, too long or poor contact with the welding cable joints caused by the proposed replacement of a length of not more than 10 meters of 50 square millimeters, and no intermediate joints of high quality welding cable to try. In short, most of the causes of this problem are because the welding loop resistance is too large;

2. Welding machine failure;

3. Wire feeder failure: wire feed speed instability, wire wheel groove metal dust too much, wire pressure adjustment is not appropriate. The The

4. Welding gun problems: wire hose is not smooth, wire and hose diameter does not match, the diameter of the conductive nozzle and the wire does not match the diameter, conductive mouth wear serious, gooseneck damage, welding cable broken cable too much.

Changzhou Terner Electrical and Mechanical Co., Ltd. located in Jiangnan Water Village, Taihu Lake coast of the Millennium town - Luoyang. Close to 312 National Road, Shanghai-Nanjing Expressway, convenient transportation and outstanding people.

The company is a science and technology enterprises, specializing in the production of various electrical products, industrial electrical control series and electric transport products 整机, parts, exported to Europe and the United States and Asia, many countries.

The company successfully passed the China Quality Certification Center of the 3 C certification, and has a large number of outstanding professionals. Since 2000, long-term commitment to the series of printed motor and a variety of wire feeder, aluminum wire, flux cored wire, long distance wire feeder and other parts of the research and development, and learn from Singapore and Europe and the United States advanced technology, Produced a variety of outstanding products.

In 2003, the company also took out a group of professionals, engaged in intelligent universal circuit breaker development research work, and the introduction of German technology for domestic and international distribution network to provide safer, accurate high-tech products and dedication to the broad masses at home and abroad Customers to provide quality services, customer satisfaction is our all Terner employees to pursue the goal. Feeding machine motor maintenance: 1, the use of the environment should always adhere to dry, the motor surface should be kept clean, the inlet should not be affected by dust, fiber and other obstacles.

   2, when the thermal maintenance of the motor continuous action, should identify the fault from the motor or overload or maintenance device set value is too low to eliminate the fault before they can be put into operation.

   3, should ensure that the motor in the course of running a good lubrication. The general motor running for about 5000 hours, that should be added or replaced grease, running in the bearing overheating or lubrication transformation, the hydraulic time for grease. When replacing the grease, remove the old lubricating oil and have the oil purge bearing and the oil sump of the bearing cap, then fill the ZL-3 lithium grease with 1/2 to 2 poles of the cavity between the inner and outer rings of the bearing) and 2/3 of the 468 pole) 4, when the end of the bearing life, the motor running vibration and noise will be significantly increased, check the bearing radial clearance to the following values, that should be replaced bearings.

   5, the assembly of the motor, from the shaft extension or non-extended end can be removed from the rotor. If it is not necessary to remove the fan, or from the non-axial extension of the rotor is more convenient, from the stator out of the rotor, should prevent damage to the stator winding or insulation.

Changzhou Terner Electrical and Mechanical Co., Ltd. located in Jiangnan Water Village, Taihu Lake coast of the Millennium town - Luoyang. Close to 312 National Road, Shanghai-Nanjing Expressway, convenient transportation and outstanding people.

The company is a science and technology enterprises, specializing in the production of various electrical products, industrial electrical control series and electric transport products 整机, parts, exported to Europe and the United States and Asia, many countries.