Automatic Wire Feeder Operation Method

Automatic Wire Feeder Operation method

Operation method editing

01. The main body of the wire feeder, the wire feeder is connected with the wire feeder and the appropriate wire tray is installed. 02. If you use foot switch control wire and

TWA-I automatic wire feeder, welding power supply and welding gun assembly diagram

TWA-I automatic wire feeder, welding power supply and welding gun assembly diagram

Spinning, only the foot switch and the control panel on the wire feed interface; such as the use of high-frequency switch gun synchronous control wire drawing, you need to control the panel on the high-frequency outlet interface with the argon arc welding machine On the high-frequency interface connection, and then the control panel on the high-frequency line and the high-frequency arc on the torch connected.

03. If you want the host computer to control the wire feeder, you need to set the internal control communication switch on the communication side of the control panel. If you do not need the upper machine control wire feeder, set the internal control switch in the control panel to the internal control side.

04. Install the appropriate wire feed wheel according to the selected wire diameter.

05. Connect the power plug, turn on the power switch, adjust the wire speed to the fastest, press the press bar, take off the foot switch, or use the control panel on the wire drawing switch, so that the wire as soon as possible to reach the wire mouth. When the wire through the wire when the wire to stop feeding.

06. Adjust the wire to make it meet the welding angle requirements. Adjust the wire feeder parameters, select the appropriate way to wire to achieve the appropriate speed.

07. Open the welding machine, the normal welding.

08. After completing the welding, turn off the power switch and unplug the power plug.

Note the editor

General safety precautions

01, please be sure to comply with the instructions specified in the instructions, or an accident may occur.

02, the design and construction of input power supply, the choice of installation site, the use of high-pressure gas, etc., in accordance with the relevant standards and regulations.

03, unrelated personnel do not enter the welding workplace.

To avoid welding dust and gas on the human body hazards

01, please use the provisions of the exhaust equipment, to avoid gas poisoning and suffocation accidents.

02, at the bottom of the container operation, the protective gas will be deposited around, causing suffocation. Special attention should be given to ventilation.

To avoid welding arc, splash and welding slag on the human body hazards

01, please wear protective glasses with enough shading. Arcs can cause eye irritation, splashing and welding slag will burn eyes.

02, please use the protection of leather with leather gloves, long-sleeved clothes, hats, feet, aprons and other protective equipment, so as not to arc, splash and welding slag burns, scalded skin.

To prevent the occurrence of fire, explosion, rupture and other accidents

01, welding sites shall not be placed combustible, splash and hot weld will cause a fire.

02, welding cable and base metal to be connected to fastening, otherwise it will heat into a fire.

03, do not weld in flammable gas or in a container containing flammable substances, otherwise it will cause an explosion.

04, do not weld the sealed container, otherwise it will break.

05, should prepare fire extinguishers, just in case.