Automatic Wire Feeder Input Power

Automatic Wire Feeder Input power

Automatic wire feeder precautions

General safety precautions

01, please be sure to comply with the instructions specified in the instructions, or an accident may occur.

02, the design and construction of input power supply, the choice of installation site, the use of high-pressure gas, etc., in accordance with the relevant standards and regulations.

03, unrelated personnel do not enter the welding workplace.

To avoid welding dust and gas on the human body hazards

01, please use the provisions of the exhaust equipment, to avoid gas poisoning and suffocation accidents.

02, at the bottom of the container operation, the protective gas will be deposited around, causing suffocation. Special attention should be given to ventilation.

To avoid welding arc, splash and welding slag on the human body hazards

01, please wear protective glasses with enough shading. Arcs can cause eye irritation, splashing and welding slag will burn eyes.

02, please use the protection of leather with leather gloves, long-sleeved clothes, hats, feet, aprons and other protective equipment, so as not to arc, splash and welding slag burns, scalded skin.

To prevent the occurrence of fire, explosion, rupture and other accidents

01, welding sites shall not be placed combustible, splash and hot weld will cause a fire.

02, welding cable and base metal to be connected to fastening, otherwise it will heat into a fire.

03, do not weld in flammable gas or in a container containing flammable substances, otherwise it will cause an explosion.

04, do not weld the sealed container, otherwise it will break.

05, should prepare fire extinguishers, just in case.

To prevent the rotation of moving parts wounding

01, do not close your fingers, hair, clothes and other rotating parts such as wire wheel.

02, into the welding wire, do not put the end of the torch close to the eyes, face and body, so as not to hurt the wire.