Automatic Wire Feeder According To The Choice

Automatic Wire Feeder According to the choice

Feed wire machine working principle and operation method:

The working principle of the wire feeder is more complex, the company after years of wire feeder research and development, a detailed analysis of his operation as follows:

01. The main body of the wire feeder, the wire feeder is connected with the wire feeder and the appropriate wire tray is installed.

02. If you use the foot switch control wire and TWA-I automatic wire feeder, welding power and welding gun assembly diagram

Spinning, only the foot switch and the control panel on the wire feed interface; such as the use of high-frequency switch gun synchronous control wire drawing, you need to control the panel on the high-frequency outlet interface with the argon arc welding machine On the high-frequency interface, and then the control panel on the high-frequency line with the torch on the high-frequency lead connection. In the case of

03. If you want the host computer to control the wire feeder, you need to set the internal control communication switch on the communication side of the control panel. If you do not need the upper machine control wire feeder, you should set the internal control switch in the control panel to the internal control side. In the case of

04. Install the appropriate wire feed wheel according to the selected wire diameter. In the case of

05. Connect the power plug, turn on the power switch, adjust the wire feed speed to the fastest, press the press bar, take off the foot switch, or use the control panel on the wire drawing switch, so that the wire as soon as possible to reach the wire mouth. When the wire through the wire when the wire to stop feeding. In the case of

06. Adjust the wire to make it meet the welding angle requirements. Adjust the wire feeder parameters, select the appropriate way to wire to achieve the appropriate speed. In the case of

07. Open the welding machine, the normal welding. In the case of

08. After completing the welding, turn off the power switch and unplug the power plug.

Wire is a very important part of the welding process, manual welding method of welding wire more than the use of welder fingers twist the wire to complete the wire feed process. Wire is a very important part of the welding process, manual welding method of welding wire and so on more than the use of welder fingers twist the wire to complete the wire feeding process, the welder operation is very inconvenient when the wire, the new TWK- I automatic wire feeder is an automatic drive of the mechanized wire feeding device, which is mainly used in manual welding automatic wire feeding, automatic welding automatic wire feeding, plasma welding automatic wire feeding and laser welding automatic wire feeding. The system adopts microcomputer control, stepping gear motor, high precision and good reproducibility.

Therefore, the accuracy of manual wire feeding is poor, the consistency is poor, and the wire feeding is unstable, resulting in a low efficiency of welding production and poor adhesion of welding. In addition, the welder hand-held wire length is limited, long time welding need to take the wire frequently, welding efficiency is low, and each welding wire will be completed when a small piece of welding wire can not be used, resulting in a waste.